1SECUREpowered by
12Plug the installation harness into the Ride module. Secure the module with the included hook & loop/cable ties.PLUG IN COREAttach the GPS ante
13RIDE includes a back-up battery to protect your bike in case of theft. The back-up battery will power the device when disconnected from power. To di
14With the provided hook & loop fasteners, mount the siren in any convenient location. Avoid areas exposed to heat, road debris or chemicals.With
15White light flashes twice every 5 seconds to indicate Transceiver Programming mode. Transceiver Programming mode lasts 3 minutes. Press and hold b
16Once the harness is plugged in confirm that there are lights illuminated on the Ride module to confirm you have good power and ground.Turn the ignitio
17TECH TIPIf the Red light and White light do not stay on solid when the ignition is on then there is a problem with the switched power (white wire) i
18Turn Ignition Off within 10 seconds. If no action taken in 10 seconds, Red light then stays on to indicate Ignition On. White light flashes every 3
19sensitivity levels. (1-5). Test shock with ignition off. Red LED will light for 1.5 seconds to indicate successful shock. Wait 1 second to test aga
20Although the sensor is pre-set from the factory it may be necessary to adjust the sensitivity to suit your specific application. ADJUSTING PERIMETER
Sensitivity can be adjusted by removing the plastic cap and tuning the adjustment screw. To increase sensitivity, turn adjustment screw clockwise. To
4To get started with Ride, install the Core device on your bike using this guide. When installing modules, refer to the respective guides. For more in
22Lights not appearing when Ride is plugged in: Check that the power and ground wires have a firm connection to the appropriate battery posts. Also ver
5Download the app and sign up for an account. Then, scan your ID and activate your subscription account.Ready to ride. Log on with the app and Rider
TABLE OF CONTENTSComponents ListPlan an InstallMounting Switched PowerAttach GPSPlug in CoreMount the ComponentsEncoding the RemoteTesting the Install
7Quick ConnectorSirenPerimeter SensorRemoteHook & Loop /Cable-tiesHarnessCOMPONENTS
8Make sure that the motorcycle battery is fully charged. Verify that no moving parts will interfere with the components.Do not route wires near sharp
9Select a suitable location under the seat or side cover that the module can lay as flat as possible. MOUNTINGThe Ride Core harness has three wires. Y
TECH TIPRIDE requires proper installation of the switched power wire to function correctly. Switched power is hot (12 volts) when the ignition is on,
11White: Install this wire to a 12 volt switched source using the provided Quick Connector. For example: the tail light or license plate light power
Comentários a estes Manuais